Installing the External Antenna
-
Temporarily place the external
antenna in the intended location, and route the cable to the location of the GOS™ 10 hub.
NOTICE
The length of the antenna cable is 1.8 m (6.0 ft.) and cannot be extended. Extending the cable could result in poor system performance.
- Connect the antenna cable to the ANTENNA port on the GOS 10 hub, screwing the connector finger-tight.
-
Using the included wrench,
tighten the antenna connector 1/4 turn.
NOTICEOver-tightening the connector by turning it more than 1/4 turn using the wrench can damage the connector.
- Test the performance of the connection with the antenna, and relocate it if needed.
- After testing and determining the ideal location for the antenna, mark the locations of the two pilot holes.
- Using a 2 mm (5/64 in.) drill bit, drill the pilot holes.
- Remove the protective covering over the adhesive on the base of the antenna and place it in the confirmed location.
- Using a #1 Phillips screwdriver and the included screws, secure the antenna to the surface.