GOS 10 Hub Power Connection
If needed, you can extend the power wires using 18 AWG (0.75 mm²) wire with solder and heat shrink or waterproof connectors.
|
Item |
Description |
Notes |
|---|---|---|
|
|
GOS™ 10 hub |
You must connect the GOS 10 hub to the same power source as the engines for the engine cutoff functionality to work properly. |
|
|
Engine or engines |
|
|
|
GOS 10 hub power and engine wiring harness |
Red: positive (+) Black: ground (-) |
|
|
1 A fuse or breaker |
You must connect the positive wire to power through either the included inline 1 A fuse, or through a 1 A breaker. If you connect the power wire to a breaker, you should remove the inline fuse. |
|
|
Ignition or external switch |
The GOS 10 hub does not turn off with the NMEA 2000® network or with other Garmin® devices. You must connect the power wire through either an accessory switch or a separate physical switch. Connecting the power wires directly to the battery will drain the boat battery when the boat is not in use. |
|
|
12 Vdc power source |