Skip to main content

Mounting the Device

Before you can mount the device, you must select a location in accordance with the mounting considerations.

You must use the included mounting screws or acquire pan-head screws of the appropriate length for the mounting surface.

NOTICE

Do not use the Garmin Spectra™ LED control module as a template when drilling the mounting holes. Drilling through the mounting holes may damage the device and void the warranty.

NOTICE

Do not apply grease or lubricant to the screws when fastening the device to the mounting surface. Grease or other lubricants can cause damage to the device housing.

NOTICE

You must use pan-head screws to secure the device. Using countersunk screws can damage the device housing.

  1. With the wiring-harness connectors pointing down, hold the device on a flat, vertical mounting surface and mark the locations for the pilot holes.
  2. Remove the device from the mounting surface.
  3. Using a 2 mm (3/32 in.) drill bit, drill the pilot holes.
  4. Fasten the included pan-head screws into the pilot holes.
  5. Secure the device to the mounting surface by tightening the screws until they are snug.
    NOTICE

    Do not overtighten the screws because it may damage the device housing.

GUID-6A3E1D9B-1E17-4069-BF5C-3C82F2202A9B v4
September 2025
© 2024 Garmin Ltd.