The floors climbed amount does not seem accurate

The floors climbed amount does not seem accurate

Your watch uses an internal barometer to measure elevation changes as you climb floors. A floor climbed is equal to 3 m (10 ft.).

Locate the small barometer holes on the back of the watch, near the charging contacts, and clean the area around the charging contacts.

The barometer performance may be affected if the barometer holes are obstructed. You can rinse the watch with water to clean the area.

After cleaning, allow the watch to dry completely.
Avoid holding handrails or skipping steps while climbing stairs.
In windy environments, cover the watch with your sleeve or jacket as strong gusts can cause erratic readings.

GUID-607F08F6-33FC-40BF-9727-84E54043D82D v3

September 2024

© 2024 Garmin Ltd.

JavaScript must be enabled in order to use this site.Please enable JavaScript in your browser and refresh the page.

The floors climbed amount does not seem accurate

Your watch uses an internal barometer to measure elevation changes as you climb floors. A floor climbed is equal to 3 m (10 ft.).

Locate the small barometer holes on the back of the watch, near the charging contacts, and clean the area around the charging contacts.

The barometer performance may be affected if the barometer holes are obstructed. You can rinse the watch with water to clean the area.

After cleaning, allow the watch to dry completely.
Avoid holding handrails or skipping steps while climbing stairs.
In windy environments, cover the watch with your sleeve or jacket as strong gusts can cause erratic readings.