Skip to main content

Attaching Your Bike to the Trainer

WARNING

For direct-drive trainers, the rear axle must be installed properly. Failure to tighten and firmly close the quick release lever may result in injury or property damage. To see a video, go to www.garmin.com/tacx/axle.

  1. Place the trainer on a firm and level surface.
  2. Attach the front leg Callout number two to the trainer using the bolts Callout number ten, washers Callout number eleven, and hex key Callout number twelve.

    Device with callouts
  3. Remove the rear wheel from your bike.
  4. Align the rear axle of the bike with the trainer frame.
  5. Tighten and close the quick release skewer or thru axle.
  6. Plug the power cable connector Callout number four into the Tacx® FLUX 2/S port.

    Bike mounted on the trainer with a callout
  7. Plug the power cable into a standard wall outlet.

    The power LED is green during normal operation.

  8. Rotate the crank arm to check for clearance.
Copyright © Garmin. All rights reserved.GUID-51949190-2A33-4BC3-94BE-16520334F98A v3