Skip to main content

Mounting the Microphone Hanger

NOTICE

If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened.

You can mount the microphone hanger in a convenient location near the radio.

  1. Select a mounting location for the microphone within reach of the microphone cable.
  2. Using the microphone hanger Callout number one as a template, mark the pilot holes.

    Microphone hanger installation with callouts
  3. Drill the mounting holes using a 3 mm (1/8 in.) drill bit.
  4. Secure the microphone hanger to the mounting surface using the included screws Callout number two.
Copyright © Garmin. All rights reserved.GUID-4E35EBDF-6BB0-4B04-89C5-4642E8D77431 v4