Bail Mounting the Device


If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened.

You can use the included bracket to bail mount the device on a flat surface.

  1. Using the bail-mount bracket Callout number one as a template, mark the pilot holes.

    Bail mount installation with callouts
  2. Using a 3.5 mm (9/64 in.) drill bit, drill the pilot holes.
  3. Using the included screws Callout number two, secure the bail-mount bracket to the mounting surface.
  4. Install the bail-mount knobs Callout number three on the sides of the device.
  5. Place the device in the bail-mount bracket and tighten the bail-mount knobs.
Copyright © Garmin. All rights reserved.GUID-4E35EBDF-6BB0-4B04-89C5-4642E8D77431 v4