Navigation Settings

Select > > Navigation.

Routing Mode: Sets preferences for how the route is created (Routing Mode Settings).
Avoidances: Sets road features to avoid on a route.
Custom Avoidances: Allows you to avoid specific roads or areas.
Traffic: Enables or disables traffic features.
Switch to Faster Route: Enables the device to automatically change to a faster route to save time when delays are detected.
Toll Stickers: Not available in every region. Sets options to avoid or allow roads that require toll stickers for each country (Avoiding Toll Stickers).
Environmental Zones: Sets the avoidance preferences for areas with environmental or emissions restrictions that may apply to your vehicle.
Restricted Mode: Disables all functions that require significant operator attention.
GPS Simulator: Stops the device from receiving a GPS signal, and saves battery power (Setting a Simulated Location).

Routing Mode Settings

Select > > Navigation > Routing Mode.

The route calculation is based on road speeds and vehicle acceleration data for a given route.

Faster Time: Calculates routes that are faster to drive but can be longer in distance.
Shorter Distance: Calculates routes that are shorter in distance but can take more time to drive.
Straight Line: Calculates a direct line from your location to your destination.

If the map data on your device contains detailed toll sticker information, you can avoid or allow roads that require toll stickers for each country.

NOTE: This feature is not available in all areas.

Select > > Navigation > Toll Stickers.
Select a country.
Select an option:
- To be asked each time before routing through an area that requires toll stickers, select Always Ask.
- To always avoid roads that require toll stickers, select Avoid.
- To always allow roads that require toll stickers, select Allow.

If you are indoors or not receiving satellite signals, you can use the GPS simulator to plan routes from a simulated location.

Select > > Navigation > GPS Simulator.
While viewing the map, tap a location on the map.

The address or location description appears at the bottom of the screen.
Select the location description.
Select Set Location.