Introduction
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Garmin® strongly recommends having an experienced installer with the proper knowledge of electrical systems install the device. Incorrectly wiring the power cable can result in damage to the vehicle, the battery, or the device and can cause bodily injury.
The device can improve situational awareness. It is not a replacement for rider attentiveness, good judgement, or checking mirrors and blind spots. Always maintain awareness of your surroundings, and operate the motorcycle in a safe manner. Failure to do so could result in serious injury or death.
The device, including the sensor, must be securely mounted and must remain stable in all operating conditions. The mounting options outlined here may not be compatible with all vehicles and may require additional hardware. Failure to securely mount this device could result in poor product performance and could cause the device to detach from its mount, which could damage the device or the vehicle and could cause serious personal injury.
If the radar device is not connected or sending radar data, Garmin recommends that you stop riding and check the devices in a safe location. Failure to do so could result in serious injury or death.
Failure to install this device according to these instructions could result in serious personal injury, damage to the motorcycle or device, or poor product performance.
The device must be installed in a manner that ensures sufficient cable slack for the entire turning range of the motorcycle’s handlebars. Failure to do so could result in poor product performance, property damage, or serious personal injury.
Adverse weather conditions and wet roads may interfere with the operation of the device. Avoid using the device in these conditions.
Routinely inspect the device and remove any dirt, debris, or other obstructions. Failure to do so could result in poor product performance or may interfere with the operation of the the device.
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vehicle.
These installation instructions do not apply to a specific vehicle type, and are meant as a guide when installing this product on your vehicle. For questions specific to your vehicle, you should contact the vehicle manufacturer.