Installing and Removing the Decorative Trim Caps
You must secure the chartplotter to the mounting surface before you can install the decorative trim caps.
The decorative trim caps for this chartplotter are made from metal. Use caution when installing the trim caps to avoid scratching the screen, and use caution when removing the trim caps to avoid bending them.
- Place a trim cap along the top edge of the chartplotter.
- Press one corner of the trim cap until it snaps into place, and then continue working toward the other end until the trim cap is securely connected to the chartplotter.
- Place the other trim cap along the bottom edge of the chartplotter, and press it into place as described in the previous step.
If you must remove either or both of the trim caps, start by pulling the ends of the trim cap away from the chartplotter to disconnect it, and then work toward the middle to remove it. If you start by disconnecting a trim cap in the middle, you might bend it.