Entering a COM1 or COM2 Frequency using the FMS Knobs:

NOTICE

The FMS Knobs must be configured in the PFW Settings to adjust the COM radio frequencies on the main PFW/MFW. Refer to the Knob Operation Section in System Overview for more information on how to configure the FMS Knobs.

  1. Push the DCK to select the standby radio frequency that needs to be tuned (The text above the DCK will change between COM1 and COM2 when the knob is pushed).
  2. Turn the Outer DCK to adjust the MHz (left of the decimal).
  3. Turn the Inner DCK to adjust the kHz (right if the decimal).
  4. Touch the COM1 Button or COM2 Button on the CNS Bar when ready to transfer the standby frequency to the active position.
190-03123-21 Rev B
October 2026