Heading Legs
Heading legs can be added and removed from the Active Flight Plan.
When adding a heading leg, it will be placed after the selected waypoint, and it can only be added when the following four conditions are met:
-
The leg is not the first or last in the flight plan.
-
The leg is not after a CI, PI, RF, FI, VM, or holding leg.
-
The leg is not before an AF, RF, PI, VM or holding leg.
-
The leg is inserting into the enroute portion of the flight plan, second departure leg, or the first approach leg for a Vectors-to-Final approach, or both the arrival procedure's final leg and its' navigation waypoint is the destination airport or runway.
After a heading leg has been entered into the flight plan, the waypoint identifier "MANSEQ" (Manual Sequence) will be the "fly-to" point until the heading leg is deleted, or the next waypoint is activated as the direct-to. While the waypoint on the 'Map' page is identified as "MANSEQ", the waypoint is identified on the 'Flight Plan' page as "Vectors".