COM Error Messages
The following COM error messages may be displayed by the system if a COM fault exists:
|
Message |
Description |
Action |
|---|---|---|
|
PILOT PTT STUCK |
The Pilot Push To Talk key has been in the pressed position for at least 35 seconds. This key will now be ignored. |
Verify Push To Talk key is not stuck. Refer to the installation manual for installation wiring tests. Contact Garmin for service if this message persists. |
|
COPILOT PTT STUCK |
The Copilot Push To Talk key has been in the pressed position for at least 35 seconds. This key will now be ignored. |
Verify Push To Talk key is not stuck. Refer to the installation manual for installation wiring tests. Contact Garmin for service if this message persists. |
|
BOTH PTT STUCK |
Both Push To Talk keys have been in the pressed position for at least 35 seconds. This key will now be ignored. |
Verify Push To Talk keys are not stuck. Refer to the installation manual for installation wiring tests. Contact Garmin for service if this message persists. |
|
TX HARDWARE FAULT |
An internal hardware problem is preventing COM transmission. |
Contact Garmin for service if this message persists. |
|
TEMP TOO HIGH |
Internal temperature is too high. |
Wait for unit to cool. Add supplemental cooling if problem persists. |
|
SUPPLY VOLTAGE LOW |
Supply voltage is too low. |
Verify supply voltage meets minimum requirement identified in installation manual. Contact Garmin for service if message persists. |