Using the Heat-Shrink Crimp Connectors
You should use the included heat-shrink crimp connectors to make a water-tight connection between the bare wires.
Only use the heat gun to apply heat to the heat-shrink crimp connectors in a well-ventilated area. Do not use the heat gun near clothing or bare skin. Doing so can result in property damage or serious injury.
-
If necessary, twist the strands of each wire
clockwise to bundle them together.
-
Insert one bare wire into one end of the heat-shrink crimp connector
.
The bare wires are not secure until they are crimped and sealed.
-
Using pliers, crimp both sides of the center of the connector
to secure the connection.