Installing the Jack Plate Bracket

  1. Identify the style of jack plate installed on your vessel.
    NOTICE
    This mount is compatible with only Atlas® brand and Bob's Machine® brand jack plates.
  2. Locate the two L-shaped jack plate brackets and choose the correct one for your vessel.
    NOTE: Bracket 1 is designed for an Atlas jack plate and bracket 2 is designed for a Bob's Machine jack plate.

    Image showing the two different brackets included in this kit with callouts
  3. Align the holes in the bracket with the holes in the side of your jack plate.
  4. Locate the included 40 mm bolts, 8 mm washers, and 8 mm nuts in the bag labeled Bag label A.
  5. Place the steel washers 1 on the bolts 2.

    Installation diagram for the jack plate bracket with callouts
  6. Insert the bolts through the bracket 3 and the jack plate 4.
  7. Place the plastic washers 5 and then the steel washers 6 on each bolt, and finger-tighten a nut 7 onto the end.
    NOTE: Do not fully tighten the nuts yet.
GUID-1492D076-511B-4A9A-9FF1-C8C50EA630BA v1
October 2026