Installing the Tilt Bracket

The tilt bracket connects to the jack plate bracket and allows you to rotate your transducer for different viewing modes.

  1. Place the tilt bracket against the jack plate bracket so that the holes align for your preferred configuration:
    • To mount your transducer in perspective mode, center the holes with the slots marked with P.
    • To mount your transducer in downward mode, center the holes with the slots marked with D.
  2. Locate three 20 mm bolts and three 6 mm washers in the bag labeled Bag label B.
  3. Place the washers 1 on the bolts 2. .

    Installation diagram for the tilt bracket with callouts
  4. Use the bolts to secure the tilt bracket 3 to the jack plate bracket 4.
    NOTE: For now, finger-tighten the bolts. Do not fully tighten them at this time.
GUID-1492D076-511B-4A9A-9FF1-C8C50EA630BA v1
October 2026