Installing the Transducer

After you have installed the transducer bracket, you can install your LiveScope™ 2 transducer on the jack plate mount.

  1. Place the arms of the transducer bracket 1 against both sides of the transducer 2 so the adapter discs press against the ridges in the transducer.

    Installation diagram for the transducer on the jack plate mount with callouts
    NOTE: You may need to spread the arms of the transducer bracket slightly so the transducer fits.
  2. Locate the 70 mm bolt, 8 mm washer, and 8 mm nut in the bag labeled Bag label C.
  3. Place the washer 3 on the bolt 4 and insert it through the transducer bracket and transducer.
  4. Finger-tighten the nut 5 on the end of the bolt.
    NOTE: Do not fully tighten the nut at this time.
GUID-1492D076-511B-4A9A-9FF1-C8C50EA630BA v1
October 2026