Installing the Transducer Bracket

The transducer bracket holds the transducer in place at your preferred installation angle.

  1. Locate six 20 mm bolts and 6 mm washers in the bag labeled Bag label B.
  2. Place the transducer bracket 1 inside the tilt bracket 2 and align the holes for your preferred angle.

    Installation diagram for the unit bracket with callouts
  3. Slide the washers 3 onto the bolts 4.
  4. Use the bolts to secure the transducer bracket to the tilt bracket.
    NOTE: For now, finger-tighten the bolts. Do not fully tighten them at this time.
  5. Locate the two adapter discs 5.
    There are two sets of adapter discs included with the jack plate mount. The all-black set is designed for use with a LiveScope™ Plus transducer, and the set with a blue ring is designed for use with a LiveScope 2 transducer. Make sure to install the discs that are appropriate for your transducer.
  6. Remove the plastic liner from the adhesive on the back of one disc and press it onto a slot on either side of the unit bracket.
    NOTE: Apply pressure to the disc for 30 seconds to ensure a strong bond.
  7. Repeat the previous step for the other disc.
GUID-1492D076-511B-4A9A-9FF1-C8C50EA630BA v1
October 2026