Performing the Autotune Procedure

Before you can begin this procedure, you must have a large stretch of open water available.

  1. When under power (not under sail), adjust the throttle so the boat travels at approximately 5 knots and provides prompt, responsive steering.
  2. Select an option:
    • If you are performing this procedure as part of the Sea Trial Wizard, select Begin.

    • If you are performing this procedure outside of the Sea Trial Wizard, on a helm control or the autopilot screen on a chartplotter, select Menu icon > Autopilot Setup > Autopilot Installation Setup > Autopilot Tuning > Autotune > Begin.

    The boat performs various zigzag motions while the Autotune is in progress.

  3. After the procedure is finished, follow the on-screen instructions.
  4. If the Autotune procedure is not successful, select an option:
    • If the Autotune procedure is not successful and you have not reached maximum cruising speed, increase the speed, select Run Standard Autotune and repeat steps 1 through 3 until the Autotune procedure completes successfully.

    • If the Autotune procedure is not successful and you have reached maximum cruising speed, reduce your speed to the initial Autotune speed, and select Run Alternate Autotune to begin an alternate procedure.

    • If the Autotune fails immediately and you are traveling in a circle instead of performing zigzag motions, select Switch Direction > Run Standard Autotune and repeat steps 1 through 3 until the Autotune procedure completes successfully.

When the Autotune procedure is complete, gain values are displayed. You can use these values to determine the quality of the Autotune procedure.

GUID-0AA4C72D-D42C-4E3C-B2D9-BE6A4A856E49 v1
September 2026