Calibrating the Compass

  1. Select an option:
    • If you are performing this procedure as part of the Sea Trial Wizard, select Begin.

    • If you are performing this procedure outside of the Sea Trial Wizard, on a helm control or the autopilot screen on a chartplotter, select Menu icon > Autopilot Setup > Autopilot Installation Setup > Compass Setup > Compass Cal. > Begin.

  2. Follow the directions until calibration is complete, taking care to keep the boat as steady and flat as possible.

    The boat should not list during calibration. Make sure one side of the vessel is not loaded more heavily than the other.

  3. Select an option:
    • If the calibration is not successful, repeat the previous step.

    • If the calibration completes successfully, select Next.

When the calibration is complete, a magnetic environment quality value is shown. A value of 100 indicates the CCU was installed in a perfect magnetic environment and calibrated correctly. If this value is low, you might need to relocate the CCU and calibrate the compass again.

GUID-0AA4C72D-D42C-4E3C-B2D9-BE6A4A856E49 v1
September 2026