Replacing the Batteries

WARNING

See the Important Safety and Product Information guide in the product box for product warnings and other important information.

Each Rally 200 pedal uses one CR1/3N battery.

NOTE: Garmin recommends replacing all of the batteries at the same time. Do not mix the battery types.

1. Use a 4 mm hex key to remove the battery cover .

   

2. Remove the battery.
3. Wait 5 to 10 seconds.
4. Insert the new battery into the battery cover, observing polarity.

   

5. Replace the battery cover, and hand tighten it.

   NOTE: Do not damage or lose the O-ring gasket.

6. Use a 4 mm hex key to tighten the battery cover to 3.6 lbf-ft. (5 N-m).

   The LED displays one short green flash followed by one long red flash.