FĒNIX 9 SERIES Owner’s Manual

Changing the QuickFit Bands

WARNING

Metal watch bands and/or watch bands that have metal parts in contact with or in close proximity to the watch housing should not be used with the fēnix 9 Pro watch due to possible signal interference with GNSS, Bluetooth®, Wi-Fi®, and LTE and satellite connected features (active inReach service plan required). Avoid the use of third-party watch bands and only use the supported non-metallic Garmin watch bands available on Garmin.com/Support/FAQ/SupportedBands.

  1. Slide the latch on the QuickFit band, and remove the band from the watch.

  1. Align the new band with the watch.
  2. Press the band into place.

NOTE: Make sure the band is secure. The latch should close over the watch pin.

  1. Repeat steps 1 through 3 to change the other band.