Installing the Mountain Bike Mount

NOTE: If you do not have this mount, you can skip this task.

1. Select a secure location to mount the Edge device where it does not interfere with the safe operation of your bike.
2. Use the 3 mm hex key to remove the screw from the handlebar connector .

   

3. Select an option:
   • If the handlebar diameter is 25.4 mm, place the thicker pad around the handlebar.
   • If the handlebar diameter is 31.8 mm, place the thinner pad around the handlebar.
   • If the handlebar diameter is 35 mm, do not use a rubber pad.
4. Place the handlebar connector around the handlebar, so that the mount arm is above the bike stem.
5. Use the 3 mm hex key to loosen the screw on the mount arm, position the mount arm, and tighten the screw.

   NOTE: Garmin recommends tightening the screw so the mount arm is secure, with a maximum torque specification of 20 lbf-in. (2.26 N-m). You should check the tightness of the screw periodically.

   

6. If necessary, use the 2 mm hex key to remove the two screws on the back side of the mount , remove and rotate the connector, and replace the screws to change the orientation of the mount.
7. Replace and tighten the screw on the handlebar connector.

   NOTE: Garmin recommends tightening the screw so the mount is secure, with a maximum torque specification of 7 lbf-in. (0.8 N-m). You should check the tightness of the screw periodically.

8. Align the tabs on the back of the Edge device with the bike mount notches .

   

9. Press down slightly and turn the Edge device clockwise until it locks into place.