Installing the Mountain Bike Mount

NOTE: If you do not have this mount, you can skip this task.

1. Select a secure location to mount the Edge device where it does not interfere with the safe operation of your bike.
2. Use the 3 mm hex key to remove the screw from the handlebar connector .

1. Select an option:
   • If the handlebar diameter is 25.4 mm or 26 mm, place thicker pad around handlebar.
   • If the handlebar diameter is 31.8 mm, place thinner pad around handlebar.
   • If the handlebar diameter is 35 mm, do not use a rubber pad.
2. Place the handlebar connector around the handlebar, so that the mount arm is above the bike stem.
3. Use the 3 mm hex key to loosen the screw on the mount arm, position the mount arm, and tighten the screw.

NOTE: Garmin recommends tightening the screw so the mount arm is secure, with a maximum torque specification of 20 lbf-in. (2.26 N-m). You should check the tightness screw periodically.

1. If necessary, use the 2 mm hex key to remove the two screws on the back side of the mount , remove and rotate the connector, and replace the screws to change the orientation of the mount.
2. Replace and tighten the screw on the handlebar connector.

NOTE: Garmin recommends tightening the screw so the mount is secure, with a maximum torque specification of 7 lbf-in. (0.8 N-m). You should check the tightness screw periodically.

1. Align the tabs on the back of the Edge device with the bike mount notches .

1. Press down slightly and turn the Edge device clockwise until it locks into place.