EDGE 1030 PLUS Owner’s Manual

Projecting a Location

You can create a new location by projecting the distance and bearing from a marked location to a new location.

Select Navigation > Saved Locations.
Select a location.
Select the location information at the top of the screen.
Select > Project Location.
Enter the bearing and distance to the projected location.
Select .

Highlight

JavaScript must be enabled in order to use this site.Please enable JavaScript in your browser and refresh the page.

Projecting a Location

You can create a new location by projecting the distance and bearing from a marked location to a new location.

Select Navigation > Saved Locations.
Select a location.
Select the location information at the top of the screen.
Select > Project Location.
Enter the bearing and distance to the projected location.
Select .