Dive Alerts
|
Alert Message |
Cause |
Device Action |
|
None |
You completed the decompression stop. |
The decompression stop depth and time flash blue for five seconds. |
|
None |
Your partial pressure of oxygen (PO2) value is above the specified warning value. |
Your PO2 value flashes yellow. |
|
%1 OTU accumulated. End your dive now. |
Your oxygen toxicity units are above the safe limit. During a dive, “%1” is replaced with the number of units accumulated. |
The alert appears every two minutes, up to three times. |
|
250 OTU accumulated. |
Your oxygen toxicity units (OTU) are at 250 units, and you are nearing the safe limit of 300 units. |
None |
|
Approaching Deco Stop |
You are within one stop interval (3 m or 9.8 ft.) of the decompression stop depth. |
None |
|
Approaching NDL |
You are at 80% of your tissue load. |
None |
|
Ascending too fast. Slow your ascent. |
You are ascending faster than 9.1 m/min. (30 ft./min.) for more than 5 seconds. |
None |
|
Battery critically low. End your dive now. |
Less than 10% battery power remains. |
The alert appears when the device is below 10% battery power and on the dive pre-check screen for your next dive. |
|
Battery is low. |
Less than 20% battery power remains. |
The alert appears when the device is below 20% battery power and on the dive pre-check screen for your next dive. |
|
CNS toxicity at %1%. End your dive now. |
Your CNS oxygen toxicity is too high. During a dive, “%1” is replaced with your current CNS percentage. |
The alert appears every two minutes, up to three times. |
|
CNS toxicity |
Your central nervous system (CNS) oxygen toxicity is at 80% of the safe limit. |
The alert appears during a dive and on the dive pre-check screen for your next dive. |
|
Decompression Cleared |
You completed all decompression stops. |
None |
|
Descend below deco ceiling. |
You are more than 0.6 m (2 ft.) above the decompression ceiling. |
The current depth and stop depth flash red. |
|
Descend to complete safety stop. |
You are more than 2 m (6.6 ft.) above the safety stop ceiling. |
The current depth and stop depth flash yellow. |
|
Do not dive. Failed to read depth sensor. |
The device has invalid or missing depth sensor data before you start a dive activity. |
Do not start a dive. Call Garmin Product Support. |
|
Failed to read depth sensor. End your dive now. |
The device has no depth sensor data. |
Use a backup dive computer or dive plan and end your dive. Call Garmin Product Support. |
|
NDL exceeded. Decompression now required. |
You have exceeded your no decompression limit (NDL) time. |
None |
|
PO2 is high. Ascend or switch to lower O2 gas. |
Your PO2 value is above the specified critical value. |
Your PO2 value flashes red. |
|
PO2 is low. Descend or switch to higher O2 gas. |
Your PO2 value is below 0.18 bar. |
If you are within the first two minutes of your dive, your PO2 value flashes yellow. Otherwise, your PO2 value flashes red. |
|
Safe to switch to %1. Switch now? |
In a multi-gas dive, a gas with a higher oxygen content is now safe to breathe. |
You can switch gases now, or wait to switch gases later in the dive. |
|
Safety Stop Cleared |
You completed the safety stop. |
None |
|
This pool dive will not be saved to the dive log. |
The device is in pool dive mode. |
The device will not save the current dive to the dive log. |