Updates & Downloads
Vector - 02 software version 4.00
as of June 22, 2016
(135 KB)
Notes:
- WARNING: If this software is uploaded to a device other than that for which it is designed, you will not be able to operate that device.
- If attempts to upload software fail, you may need to return the device to Garmin® for service.
Change History
Changes made from version 3.90 to 4.00:
- Properly enable the status LED to prevent the unit from appearing non-functional when an incomplete mechanical connection between the pod and spindle occurs.
Changes made from version 3.81 to 3.90:
- Correct accelerometer start-up error that was preventing meaningful data from being captured and reported
- Fixed a condition where Vector could cause a display to divide by zero when receiving torque data
- Install angle can be set in a pedal to pedal disconnected state.
- Improved battery monitoring to make it less susceptible to sampling noise
- Improved handling of parameter conflict between multiple displays
- Prevent users from setting scale factor outside of the 0.75 to 1.25 range
Changes made from version 3.50 to 3.81:
- Corrected two radio issues that were causing persistent loss of data reception either from the left side or from the entire system.
- Improved pedal to pedal sync time.
- Reduced opportunities for spontaneous un-pairing of pedals.
- Corrected a math error that was causing periodic balance spikes.
- Transmit time-averaged torque while coasting.