Updates & Downloads
Edge 1030 Bontrager software version 13.71 Beta
as of October 24, 2022
View installation instructions and system requirements
Notes:
- Although this software is believed to be reliable, it has not yet been released for production and should be used at your own risk.
Change History
Changes made from version 13.50 to 13.71:
- Added RCT715 recording status indicator.
- Added support for saving photos and video clips on the RCT715 when the camera is disabled or busy.
- Added support for turning off RCT715 video recording when suspending or powering off the Edge.
- Updated to CIQ API version 3.3.6.
- Fixed issue where connectivity firmware would cause the device to freeze.
- Fixed potential device freeze when importing read-only GPS files
- Fixed issue where courses with no recorded elevation data would result in a blank ClimbPro elevation profile.
- Fixed issues with indoor trainer controls in ERG and manual modes.
- Fixed time zone offset when syncing time with the phone without a valid time from GPS.
- Fixed issue where ephemeris status would incorrectly be displayed as expired.
Changes made from version 13.10 to 13.20:
- Fixed issue causing VO2 max to not be calculated and performance condition from working.
Changes made from version 12.00 to 12.14:
- Fix issue with Fazua BLE scanning
- Fix crashes drawing third party maps
- Fix issue unlocking maps from SD card
Installation Instructions
- Connect your Edge 1030 Bontrager device to your computer using the micro-USB cable.
- Download and unzip Edge1030Bontrager_1371Beta.zip and place the GUPDATE.gcd file in the \Garmin folder of your device's internal storage drive.
- Disconnect your device from the computer, approve the update on the Edge, and wait for the update to finish.
- If you would like to revert to the last public release software, follow the above steps but place the GUPDATE_1350.GCD file in the \Garmin folder. Rename the file to GUPDATE.GCD before disconnecting your device.
NOTE: If you revert to an older version of software, all of your settings will be reset to defaults.
System requirements
- IBM-compatible PC running Windows 2000 or later operating system and an available USB port.