Updates & Downloads
Rino 520HCx/530HCx software version 3.40
as of November 7, 2012
(3.28 MB)
View system requirements
Notes:
- WARNING: If this software is uploaded to a device other than that for which it is designed, you will not be able to operate that device.
- If attempts to upload software fail, you may need to return the device to Garmin® for service.
Change History
Changes made from version 2.90 to 3.40:
- Added support for new battery.
Changes made from version 2.80 to 2.90:
- Add support for downloadable content.
Changes made from version 2.70 to 2.80:
- Added support for maps greater than 2 GB.
Changes made from version 2.60 to 2.70:
- Fixed issue with waypoint symbols not showing correctly on the map
Changes made from version 2.50 to 2.60:
- Fixed potential shutdown on map setup page when a large map set is loaded.
Changes made from version 2.40 to 2.50:
- Unit will now respond to the power key in USB mass storage mode.
- Fixed Trackback navigation to properly show ETA and ETE information.
- Fixed issue where the ETA would be unreasonably short for pedestirans and bikers.
- Fixed issue in the barometer so it is now more accurate.
- Improved anchor alarm to increase the volume if it is zero and made tone persistent.
- Backlight adjustment will now work on the Trackback point selection page.
- Fixed a memory leak related to the altimeter page.
Changes made from version 2.30 to 2.40:
- Fix potential shutdown when editing a waypoint using the Estonian grid.
- The scan feature should now switch to the appropriate channel when a signal is received.
- Fixed an issue where the incorrect altitude was sent over the radio at high altitudes.
Changes made from version 2.20 to 2.30:
- Contact waypoints should now show time and status properly.
- Added hunting user waypoint symbols.
- Added Estonian and SWEREF 99TM grids
System requirements
- IBM-compatible PC running Windows 7 SP1 or later operating system and an available USB port.