Updates & Downloads
Xero A1(i) software version 3.70
as of March 18, 2021
(419 KB)
View system requirements
Notes:
- WARNING: If this software is uploaded to a device other than that for which it is designed, you will not be able to operate that device.
- If attempts to upload software fail, you may need to return the device to Garmin® for service.
Change History
Changes made from version 3.60 to 3.70:
Changes made from version 3.40 to 3.60:
- Added support for decimal precision on the level page.
- Added support for enabling 5 quick trigger taps to exit stalk mode.
- Fixed issue where the maximum allowed manual range would stop short of the maximum calibrated range.
Changes made from version 3.30 to 3.40:
- Added support for German language files.
Changes made from version 3.20 to 3.30:
- Fixed issue where a pin would not be displayed when targeting close to the max range.
- Fixed issue where the wrong maximum estimated range was displayed while manually adjusting the pin stack.
Changes made from version 3.00 to 3.20:
- Added support for stalk mode. Stalk mode allows the device to remain on, but deactivates the trigger key to prevent errant presses. Stalk mode can be enabled by holding the power key.
- Added ability to hold left and right keys while adjusting a manual range.
- Fixed possible issue with no range given for steep angle cases.
- Fixed possible lockup.
Changes made from version 2.90 to 3.00:
- Added level indicator that can be viewed along with the ranged pin.
- Added ability to zero out the level.
- Added support for new statistics mode. This mode will collect data during practice sessions to assist in the archer's accuracy training.
- Added support for new competition tracker. When this option is enabled, shot dynamics will be saved for each shot. This shot data can then be found in a file on the device.
- Added ability to move the user's entire pin stack.
- Fixed possible issue where fixed pins would be mistakenly deleted.
- Improved functionality of laser range finder.
Changes made from version 2.80 to 2.90:
- Fixed a potential lock up
Changes made from version 2.70 to 2.80:
- Improved short range and steep angle pin calculations.
- Improved setup of new arrow profiles for A1i units.
Changes made from version 2.60 to 2.70:
- Fixed private laser location transfers
- Improved shot detection
- Improved reticle behavior/settings
Changes made from version 2.50 to 2.60:
- Fixed an issue with fixed pin setup for XERO A1 devices
- Improved shot odometer
Changes made from version 2.40 to 2.50:
- Fixed shot metric loop
- Changed software update banner
System requirements
- IBM-compatible PC running Windows 2000 or later operating system and an available Com 1, 2, 3, or 4 port.
- PC Interface Cable for your GPS unit. The PC Interface Cable may be purchased through your local Garmin distributor or ordered direct from our Online Store.